With increasing customer demands for test products, in
a rapidly expanding sector of optical fibre-based telecommunications,
Trend are excited to announce the introduction of a new range of 6 Fibre
Optic testers to complement its existing product line.
The new products include Optical Power Meters, Attenuators and Multimeters
which are simpler and far lower in cost than the premium versions hitherto
supplied, new Laser Sources, Fibre Identifiers and Fault Locators, and
a PON Power Meter.
-The Fibre Identifier is an essential installation and maintenance tool
used to identify power and traffic direction in jacketed or bare fibre
without service interruption. The clamp design allows the tester to detect
light in the fibre without damage or disconnection and with low bending
loss.
-The Visual Fault Locator is used for the location of
faults in single-mode and multi-mode fibres using light in the visible
spectrum to reveal bad connections,
fibre breaks and excessive bending in jacketed or bare fibre.
-The Optical Light Sources are simple to use transmitters
that can be used in conjunction with other types of test equipment, such
as power meters and fibre identifiers, to test fibre optic cables. There
are three types in the range to cater for up to four different wavelengths,
on Single Mode and Multimode fibre.
-The Optical Power Meter is a simple to use instrument
that can be used to measure the output power from optical equipment or,
in conjunction with other types of test equipment, such as laser sources,
to test fibre optic cables.
-The Optical Multimeter combines the functions of a Laser
Source and a Power Meter into a single simple to use instrument used to
test fibre optic cables and equipment.
-The PON Power Meter is an optical power meter optimized
for use in Passive Optical Networks (PONs), increasingly used to implement
point-to-multipoint Fibre to The Premises (FTTx) installations.
GUNTONG TECHNOLOGIES HOLDING SDN
BHD
